Oh yea got my old job back after layoffs from too many accident reports. Basically lost my job and almost lost my house, have a wife, she's full time student, mother & pregnant 11 weeks, to take care of. Was a tough 3 months bit I'm back on my feet incase anyone was concerned about my previous post! Hope everyone is doing ok through these hard times, honestly last year was the hardest ever for me, even the recession in the 90's wasn't as bad as last year. I think I made like 28k compared to the 85k I averaged. Thank god for unemployment, mortgage assistance programs & good ol bankruptcy lol.
good find. I think I have a couple 360 ragnarock chips. I may have one macro also. (all for the 360) let me know if you want them and I can ship them out.
Just found a old matrix 2 xbox360 controller with a old viking ragnarok matrix2 mod chip. Looked everything over, soldered a few broken wires and now have a working 360 ragnarok. Found the old drivers for firmware updates and got it from ver 1.5 to ver 1.9.1.
I have since been successful completing basic mods on xbox one and ps4 controllers. I honestly think that they wired it wrong to begin with but I cant find ANYTHING SHOWING ANY SORT OF DIAGRAM anywhere on the internet
Well going to be a dad again. Just before hitting 40 and getting fixed lol. Had an appointment with my doctor to get snipped tomorrow but just found d out today my wife's pregnant. Now my daughter will have a sibling to play with, I just hope I get another girl. Dont think I have the energy to raise a boy.
Go to the upper left where it says forums. In the forum section select the sub forum that best fits your question. Theres legacy PS to modern, legacy xbox to modern, and so fourth. U just have to surf through the topics that fall under your category of question.
ok forum looks to be back up and working now. I've spoken to matt and probably going to look at moving the forum up one directory to the main site so there isn't the splash screen anymore as the shops are no longer in operation
Scratch that, wasn’t able to get enough time with it other than to trace out the face buttons. I wasn’t about to pay even more for something out in 5 days anyway
Will have to wait for China to invest in the tooling for clone shells before the aftermarket mods take off... or be skilled with JB weld I suppose lol low quality scans coming soon assuming I don’t just let RDC do more professional ones first :P