Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Topic started by: CptChronic on January 31, 2018, 12:19:12 PM
-
Can anyone on here make a flexible pcb on CAD for me or know someone that will please? I need it for the xbox one S controller.
If all goes well I'll also have one for the older xb1 versions and maybe PS4 too. With a new one everytime a new version is released.
Obviously for cash.
Thanks
-
FPC design isn't much different than PCB design when you get down to it. The design parameters of it would dictate most of the cost, but that can get into a real mess depending on if it needs to be tested first, redesigned and so on. Expect having the actual FPC made to be more expensive by comparison to a similar PCB design. It also costs a bit more on the assembly side if you're going that route.
(https://www.acidmods.com/RDC/miniM4pper/X1Ds%201708.jpg)
(https://www.acidmods.com/RDC/miniM4pper/X1Ds_1708.jpg)
-
Thanks for the reply RDC. I know it's not going to be cheap, been thinking of trying to make one myself but I have no knowledge on cad at all.
At the moment it's taking me around an hour to install this new mod, so many wires :confused: plus it's an 18f chip so soldering it to the mini circuit board before installation to the controller is a nightmare as the legs are so small and close together.
The other one I have only takes 5 minutes but isn't as good so I need to get moving with the new one.
The one you have posted there would be perfect, it's a different chip though