Author Topic: XBox One PCB LED help...Please and Thank You!  (Read 2584 times)

Offline Iceman21J

  • Guppy
  • *
  • Posts: 1
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
XBox One PCB LED help...Please and Thank You!
« on: October 02, 2015, 10:46:40 PM »
Hello,

I would first like to say thank you to all who provide input on this issue.  Any and all suggestions are greatly appreciated.
I have an issue regarding my xbox one controller.  I made an attempt to swap out the guide button LED. I've done many LED mods on my xbox 360 controllers and have been very successful. My first attempt on Xbox One controller failed. When desoldering the negative side of the original LED, I accidentally lifted the solder pad.  I have done this on other PCBs and fixed it by finding a trace to jump to. However, I can't find a trace for the negative side of the LED to jump to.  Does anyone know where this trace is? I am currently using my controller with no guide button light at all. 

Once again, thank you very much for your help!

Offline FOOKz™

  • Hardware Modder
  • Research & Development
  • E = MC² Mad Scientist
  • *
  • Posts: 2070
  • Post quality +37/-2
  • Electronics Expert Electrical Engineer
Re: XBox One PCB LED help...Please and Thank You!
« Reply #1 on: October 21, 2015, 08:44:32 PM »
A good fella, RDC, posted some qualify circuit board scans that can be found here:

https://www.acidmods.com/forum/index.php?topic=43204.0

You're welcome.

Follow my Instagram and subscribe to my YouTube

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal