Author Topic: DualShock 4 Controller PCB scans  (Read 92773 times)

Offline RDC

  • Acid Modder
  • *
  • Posts: 761
  • Post quality +78/-2
  • Gender: Male
  • The CGnome Project
Re: DualShock 4 Controller PCB scans
« Reply #120 on: January 04, 2018, 06:08:10 AM »
If you remove that carbon coating then the connections to the daughter board are pretty much ruined. While you probably could recoat them, it would be unreliable as there would be solder all over the copper and then new coating on top of that instead of on the copper. You would be better off just getting another controller after messing with that one.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.