Author Topic: How to make a molex power supply!! and 12v model schematic  (Read 3902 times)

Offline djaaron

  • Guppy
  • *
  • Posts: 4
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
How to make a molex power supply!! and 12v model schematic
« on: October 16, 2012, 06:22:41 AM »
Hello all i made this pdf step by step tutorial with lots of pic's to make it noob friendly.
If you still need Help with any thing just ask.
Click Here

12v model schematic diagram.( One with power led's to show the out put power is ok and one with no led's )
CLICK HERE 
Warning this is good for about 1 AMP ok for a ck3 but not recommended brunner max drive!!!!

Thanks Aaron,

Offline cobi_vw

  • Motor Mouth
  • *
  • Posts: 91
  • Post quality +4/-0
  • Gender: Male
  • PSP-Direct Team
Re: How to make a molex power supply!! and 12v model schematic
« Reply #1 on: October 16, 2012, 09:08:20 AM »
Nice tutorial,  :tup:

Offline Luigus

  • Who Farted ???
  • *
  • Posts: 219
  • Post quality +6/-3
  • Gender: Male
  • PSP-Direct Team
Re: How to make a molex power supply!! and 12v model schematic
« Reply #2 on: October 16, 2012, 09:41:52 AM »
nice idea man, maybe just check your spelling twice :P

i would definitely think of doing something like this myself.

Offline djaaron

  • Guppy
  • *
  • Posts: 4
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: How to make a molex power supply!! and 12v model schematic
« Reply #3 on: October 16, 2012, 10:37:50 AM »
Dude i am dyslexic i'm not the best speller  but i try my best i just hope the people on the forum can over look that and use the useful part of my post.

Offline Nevbox

  • Granny Spanker
  • *
  • Posts: 356
  • Post quality +12/-5
Re: How to make a molex power supply!! and 12v model schematic
« Reply #4 on: October 16, 2012, 10:55:10 AM »
Note: With some molex cables the metal used in the wire can not be tinned due to the alloy, with this kind of wire you must cut the molex connector up and take out the pins and solder onto them.

Also removing the power connector from the board requires a high wattage iron, because of the high melting point solder used :)

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal